Hi Guys,
I have programed my ESC 130 A in IR mode successfully. When I switch to PPM mode to do the throttle collabartion on hight stick its reads the value and after moving the stick to low position then give the desired beep but after that start countinously blinking with orange light.
I have already checked my transmitter is properly bind with receiver. During this process my beastx initialized and if I give any stick put to swash its work properly so dont understand why its beeping continously. I have already reconnect the motor connection as well but still same. Please advise if any one face this similar issue.
Regards,
Fadi
I have programed my ESC 130 A in IR mode successfully. When I switch to PPM mode to do the throttle collabartion on hight stick its reads the value and after moving the stick to low position then give the desired beep but after that start countinously blinking with orange light.
I have already checked my transmitter is properly bind with receiver. During this process my beastx initialized and if I give any stick put to swash its work properly so dont understand why its beeping continously. I have already reconnect the motor connection as well but still same. Please advise if any one face this similar issue.
Regards,
Fadi