Linear Throttle Response with the new thesteve mcpx and the old thesteve version

I would like clarification on getting a linear throttle response using the thesteve mcpx version. I searched the forum and found several threads. I figure I will summarize it up with one thread.
[The photos are from those posts in which I have gathered up. I would give credit but I can't find those threads.]

I have this thesteve version from wow.
I have a v1 3in1 board mcpx

To achieve a linear throttle response, I would need to solder the yellow wire to a resistor on the 3 in 1 board and also remove a resistor on thesteve version as well? However, if I have the old version of thesteve, I would just need to solder the yellow wire to the 3 in 1 board only?

The soldering point for the yellow wire for a v1 and v2 board are depicted by the photos.

[v1 board]


[v2 board]


The resistor you must remove from thesteve version is shown by the photo.



Is this correct?