ok so converted my mcpx v1 into brushless with the PnP kit from heli depot the heli has been flying flawless for the past week with a few crashes on grass throttle hold every crash no major damages just poped links ect then back up and flying withen minutes.....anways yesturday during my lunch our i was flying and notice my tail felt spoungy/loose as if it was a bigger sized heli with very low tail gain if i go for a flip it sorta blows out even on agressive pitch pumps
my pitch is -80 +80
throttle flate 80%
using nanotech 600mah
ive replaced every shaft gear and blade with new ones to see if this was the problem but no ive replaced my tail boom with a new rod and still cant get tail to hold.
only idea i can think of is one of the dual tail motors is cutting out...? both motors are spinning when i spool up in hand....
my pitch is -80 +80
throttle flate 80%
using nanotech 600mah
ive replaced every shaft gear and blade with new ones to see if this was the problem but no ive replaced my tail boom with a new rod and still cant get tail to hold.
only idea i can think of is one of the dual tail motors is cutting out...? both motors are spinning when i spool up in hand....