ok yesterday i had basically a stock mcpx other than a aftermarket swash plate and kdbb blades and tail and extended tail boom. flies fine, hovers all of that good stuff. so yesterday i had a few things come in the mail, like 300mah battery, mia micro flight kit, extreme rotor hub, and extreme main grips and solid main shaft. put eveything on and before i put the rotor hub on i used a swash level tool and made sure eveythinbg was level--check .
put it all together and checked pitch and 0 stick with throttle hold on. was off a tad and adjusted. threw a battery in her and at 3/4- full throttle it barely has enough lift to get off the ground... WTF ???
pulled battery and rebinded, still same issue. checked main gear, nice and up tight.
what i do notice is while at mid stock with TH on the blades are level. but when i sweap from neg to pos. there isnt a large span like there was when i had checked it in the past. before when i would check it it seemed like a much larger span in between full neg and full pos.
are the mods ive done affecting this ? should i put my links into another hold on servo ??
put it all together and checked pitch and 0 stick with throttle hold on. was off a tad and adjusted. threw a battery in her and at 3/4- full throttle it barely has enough lift to get off the ground... WTF ???
pulled battery and rebinded, still same issue. checked main gear, nice and up tight.
what i do notice is while at mid stock with TH on the blades are level. but when i sweap from neg to pos. there isnt a large span like there was when i had checked it in the past. before when i would check it it seemed like a much larger span in between full neg and full pos.
are the mods ive done affecting this ? should i put my links into another hold on servo ??