So I tried out my 7Hv with my Logo 600 pack, Hyperion 10S 4500 35C and Edge 713's
Wanted to feel out how it felt with light packs and this one being 1180g's it is close to the 6S 4000's I'm looking at.
With my Scorpion 4035-560 and 13t pinion I got 1750 and only used 1846Mah in 5mins
Machine had a bad shake at this HS, you could see the frame and skids shimmy. It got a little better at 1650. I will check my dampers for any slop but can't imagine so at less than 30 flights now.
The machine at that low weight was pretty quick still even at the lower head speeds.
I am going to try to lighten up my machine some with smaller packs and maybe go back to 690's. My Pyro 700-45 should be on it's way back soon with fresh bearings and a longer shaft to reach the counter bearing which will save a few G's
I have a few other ideas to lighten it up further, will post when I get done.
Wanted to feel out how it felt with light packs and this one being 1180g's it is close to the 6S 4000's I'm looking at.
With my Scorpion 4035-560 and 13t pinion I got 1750 and only used 1846Mah in 5mins
Machine had a bad shake at this HS, you could see the frame and skids shimmy. It got a little better at 1650. I will check my dampers for any slop but can't imagine so at less than 30 flights now.
The machine at that low weight was pretty quick still even at the lower head speeds.
I am going to try to lighten up my machine some with smaller packs and maybe go back to 690's. My Pyro 700-45 should be on it's way back soon with fresh bearings and a longer shaft to reach the counter bearing which will save a few G's
I have a few other ideas to lighten it up further, will post when I get done.