I have double & triple checked my throttle & pitche curves for norm & stunt fmodes. All of my settings in the tx are correct as far as being linear & curved in the corresponding flight mode. When I was doing my routine weekend pre/afterflight check I noticed when I toggle ON stunt mode while throttle hold is on, there is no jump in the servos. Which are fairly new never crashed hs-65hbs, the pitch range does not increase. Do my throttle HOLD settings have anything to do with this? 99% of the time I set/check everything mechanicaly using throttle hold, should I actually pull the motor wires & start over? I do move the sticks as well when setting up the throttle & pitch curves. Should my throttle hold settings be changed when going from set up to actual flight? the heli flies fine & in idle up it flies the way it should for how I have it set up; low & high points are 100%, mid pt is at 75%. Its doesn't seem like the servos are traveling enough in the neg- direction. Anyhow, do throttle hold settings, & using t hold to set up the heli have any affect on the pitch range?
↧