Rebuilt the engine... checked everything.. had to use the fan puller for getting the hub out. The scres provided with the puller were too small and freakin stripped the holes on my hub...
I used longer ones, and then some twisting, and finally I got it out. YES.. the last user had gotten some loctite or something in there..
Engine had a broken rear bearing.. and apparently this heli has had some 3D flying.. the guy shimmed the head, for higher fuel percentage and power.. I took that off as I am gonna use only 15 percent or 30 percent..
Video of breaking in will come soon..
You dont thing that half stripped holes will create an issue. ?? will they? the screws got secured towards the end, so the end part was not stripped..
let me know! i'll update y'all! :)
here is my setup..
DS8717's all over
GY501 with S9253
Pushglow
OS #8
Life battery
Multigov
magnet on clutch rpm sensor
Carbon Fibre blades (which I will put GF for now until I get confident with this heli.. those are the only carbon fibres I got.
12 degree setup
AR6200 with satellite
I used longer ones, and then some twisting, and finally I got it out. YES.. the last user had gotten some loctite or something in there..
Engine had a broken rear bearing.. and apparently this heli has had some 3D flying.. the guy shimmed the head, for higher fuel percentage and power.. I took that off as I am gonna use only 15 percent or 30 percent..
Video of breaking in will come soon..
You dont thing that half stripped holes will create an issue. ?? will they? the screws got secured towards the end, so the end part was not stripped..
let me know! i'll update y'all! :)
here is my setup..
DS8717's all over
GY501 with S9253
Pushglow
OS #8
Life battery
Multigov
magnet on clutch rpm sensor
Carbon Fibre blades (which I will put GF for now until I get confident with this heli.. those are the only carbon fibres I got.
12 degree setup
AR6200 with satellite