This is really a new motor I have for sale. I bought the Viper VSH 6013 new and it has a very small wobble and one of the set screws in end of can was crooked. I sent it back to Viper RC and they replace with this one.
I have never installed in helicopter, only bench tested it with a ducted fan blade attached for a load and Align 70 amp ESC.
It runs true and smooth. I am a Machinist of 30 years and picky about runout.
It fits the Align 550 frame with out mods.
Specs:
1300 kv 6S Lipo
6mm shaft with flat
Braid protected leads with 4mm bullets
11.81 oz
High Precision long life Japan bearings, 2 on the bottom end.
Only selling because I am going Kontronik Jive ESC and Pyro Motor.
Thanks for looking
$100 shipped and PayPal
Will take Personal check if want to wait till cleared.
I have never installed in helicopter, only bench tested it with a ducted fan blade attached for a load and Align 70 amp ESC.
It runs true and smooth. I am a Machinist of 30 years and picky about runout.
It fits the Align 550 frame with out mods.
Specs:
1300 kv 6S Lipo
6mm shaft with flat
Braid protected leads with 4mm bullets
11.81 oz
High Precision long life Japan bearings, 2 on the bottom end.
Only selling because I am going Kontronik Jive ESC and Pyro Motor.
Thanks for looking
$100 shipped and PayPal
Will take Personal check if want to wait till cleared.