Ok folks I need alittle help here.
Today I finished flying and changed my route alittle. Normally I unplug my main lipo and 2s rx pack at the flight line then carry the machine back to the bench. Today the flight line was really busy so I wanted to get out of the way. I disconnected the esc from the lipo (still had the anti-spark wire connected) and carried it back to the bench. The flight was great and I had no problems at all. So back at the bench I struggle to remove my dang 6HV canopy so I can disconnect the main connector from the lipo to esc (and thus disconnecting the anti-spark wire). Before I manage to do this I notice my Tx has no control over my Beastx !! Unfortunately my memory sucks and I didn't think to really keep track of what lights were flashing but the status LED was either red or flashing red, and one of the letter leds was flashing, I think it was "D" but it could have been C or E. I disconnected the rx pack and power it back up and it works fine. But I would like to know what the heck I did before I fly it again.
i've been talking to Dana about this and he think I might have gone into a menu mode while trying to remove the canopy, and I think this is the most likely cause. But I would like to know if anyone knows of any error codes or such that would correspond to what I saw.
Today I finished flying and changed my route alittle. Normally I unplug my main lipo and 2s rx pack at the flight line then carry the machine back to the bench. Today the flight line was really busy so I wanted to get out of the way. I disconnected the esc from the lipo (still had the anti-spark wire connected) and carried it back to the bench. The flight was great and I had no problems at all. So back at the bench I struggle to remove my dang 6HV canopy so I can disconnect the main connector from the lipo to esc (and thus disconnecting the anti-spark wire). Before I manage to do this I notice my Tx has no control over my Beastx !! Unfortunately my memory sucks and I didn't think to really keep track of what lights were flashing but the status LED was either red or flashing red, and one of the letter leds was flashing, I think it was "D" but it could have been C or E. I disconnected the rx pack and power it back up and it works fine. But I would like to know what the heck I did before I fly it again.
i've been talking to Dana about this and he think I might have gone into a menu mode while trying to remove the canopy, and I think this is the most likely cause. But I would like to know if anyone knows of any error codes or such that would correspond to what I saw.