It's a hp05 xp 7a and the Steve setup
As soon as o get to about half throttle the motor rpm cuts down and stays like that for the rest of the throttle . Idle up does the same thing
Not quite sure what the issue is here. Everything is correctly wired. I'm using the small resistor on the bsck, I'm under the impression that if you used the back of the board spot there was no need for a resistor on the v+ to the steve the only thing I can think of is I'm using two 300mah 35c lectron pro packs but that should be plenty. Could it be the voltage latch up? Or do I need to program my esc? What do you guys think? This is my first brushless that I have built