I had a bad 120sr tail motor that I just replaced. The new one seems to be working fine but when I give it any power, the tail just spins out CCW. I've checked everything that I know to check.
Main HP05 motor spinning CW.
Tail Motor Spinning CCW.
Everything is tight with no apparent vibrations.
I did shorten the 120sr wires and resoldered them to the white connecter that then goes into the board.
Could I have a cold solder joint at the connector?
Main HP05 motor spinning CW.
Tail Motor Spinning CCW.
Everything is tight with no apparent vibrations.
I did shorten the 120sr wires and resoldered them to the white connecter that then goes into the board.
Could I have a cold solder joint at the connector?