Hello All,
I was wondering if anyone had any suggestions. I just purchased a mCPx version 2 and setup my dx6i controller with all the preferred settings. One of the things I first noticed is the main rotor blades do not spool up nice and slow. I have to give it more than 1/8 of throttle before the main blades start to spin. Before this time the tail blade is already spinning. I also have a blade 120sr and the throttle is very sensitive and the blades start to spin up with very little throttle.
Is this typical with the mCPx version 2? Also I noticed when it let go of the throttle the blades spin down and then they catch and stop towards the end. Seems like something is binding somewhere?
Thanks,
Ryan
I was wondering if anyone had any suggestions. I just purchased a mCPx version 2 and setup my dx6i controller with all the preferred settings. One of the things I first noticed is the main rotor blades do not spool up nice and slow. I have to give it more than 1/8 of throttle before the main blades start to spin. Before this time the tail blade is already spinning. I also have a blade 120sr and the throttle is very sensitive and the blades start to spin up with very little throttle.
Is this typical with the mCPx version 2? Also I noticed when it let go of the throttle the blades spin down and then they catch and stop towards the end. Seems like something is binding somewhere?
Thanks,
Ryan