So I've been looking around for a buffer/backup 2s LifeP04 that I can use for this purpose...I found this pack and am wondering what you guys think...
Its really small and would be a very clean setup, as it has a built in switch. With HV servos at 7.4v the amp draw is pretty small, and I think it would be sufficient, especially if all it really is for is to complete an auto in the event of a failure!
What I'm wondering is that its rated at 15c which should be fine..but the lead wires aren't that robust maybe 24g. Also the built in switch is handy, but do you think it would be sufficient to take the load of 4 HV servos? I know it depends on the specs..but what do you guys think??
http://www.dynamiterc.com/Products/D...ProdID=DYN1418
Its really small and would be a very clean setup, as it has a built in switch. With HV servos at 7.4v the amp draw is pretty small, and I think it would be sufficient, especially if all it really is for is to complete an auto in the event of a failure!
What I'm wondering is that its rated at 15c which should be fine..but the lead wires aren't that robust maybe 24g. Also the built in switch is handy, but do you think it would be sufficient to take the load of 4 HV servos? I know it depends on the specs..but what do you guys think??
http://www.dynamiterc.com/Products/D...ProdID=DYN1418